For the Dental Lab

Description of the Partial Flex® Prosthesis manufacture in the dental laboratory
The manufacturing process of the prosthesis made from Partial Flex material is described in the following:

injection_machine

Taking impression of the affected part of the jaws or maxilla
Impression sent to the laboratory
Block the gypsum model
Duplicate the model
Articulate the model
Wax the model
Enflask the model
Remove the wax by a melting process
Cool down the flask and apply the sealant Seal Flex
Preheating the Partial Flex tube in the oven for 13 min at 260°C
Inject the prosthesis Partial Flex material into the mould
Let plastify for 15 min at room temperature
Take our of gypsum mold
Adjust the prosthesis, check occlusal bite
Complete by finishing process including polishing and shining
Send to treating dentist

PARTIAL FLEX® Resin
Directions for use with the PARTIAL FLEX® Manual Machine.

tubes

Indication for Use:
The Partial Flex® Resin is a product used to produce temporary flexible Partial and full prosthesis. To increase the "standard" mix with metal.

Contraindications:
Partial Flex® is a provisional Material
Do not use more than 12 hours
Never use as a unilateral prosthesis. Use a bilateral framework design ALWAYS.

Warnings:
When using the Partial Flex® Manual Machine extreme caution must be used to avoid skin contact with the oven, portatubes, hot flask .Always use heat resistant industrial gloves with rating of least 300ºC.

Precautions:
When polishing a Partial Flex® restoration , mask ,ventilation and vacuum systems should be used.
Use the heating times to achieve the exactly base shade.

Adverse Reactions:
Particules will be generated when polishing a Partial Flex® restoration. Skin, Eyes and respiratory irritation may occur if appropriate safety precautions are not taken.

Heating:
Turn on the Partial Flex® oven with the portatubes pre lubricated with a silicon spray sleeve in place and set 260º C at least 30 minutes prior processing.
Using heat resistant industrial gloves spray a silicone spray before to insert the tube the green, red o blue point must be facing out. Insert the tube into the portatubes as far as possible and put the injection top.

Time:
Heating the tube for 13 minutes. DO NOT HEAT LONGER THAN 20 MINUTES MORE MINUTES OR MORE THAN 260 º TEMPERATURE WILL RESULT A DIFFERENT SHADE.